Seismic
base isolation is now an accepted practice, in many parts of the world, for
protecting important buildings from earthquake forces. For low to moderate
height buildings, natural rubber
bearing
has often been considered suitable because of its durability and easier
fabrication. Many recent studies showed that low stiffness of base isolation systems
could cause unacceptably large displacements of ground floor of the building
necessitating substantial amount of damping in the isolation system.
INTRODUCTION
The
base isolation system consists in introducing low stiffness bearings and damper
between foundation and superstructure. Bearings provide the needed flexibility
to the combined system so as to shift its first mode natural frequency away
from predominant frequency of the design earthquake motion. This results in the
reduction of inertial forces and accelerations several times. The idea behind
base isolation has been proposed again and again for at least a century.
Earlier the elastomeric bearings were made up of natural rubber, which possess
very low energy dissipating capacity resulting in unacceptably high
displacements at isolation level. Recent advances in rubber technology have
enabled the manufacturers of these bearings to have better control over the
structural properties of the rubber. This is achieved by mixing suitable amount
of certain chemicals in the natural rubber. These filled rubbers can be used
efficiently in the manufacture of isolation bearings. The laminated rubber
bearings made by these filled rubbers have high initial stiffness, which
reduces, at high level of shear strains. Therefore, behavior of these bearings
can be simulated by bilinear curve. The area of hysteretic loop i.e. damping
for an earthquake event is controlled by yield force and post-to-pre yield
stiffness ratio of the bearing which can be controlled by fillers. The purpose
of this paper is to investigate the effectiveness of base isolation by filled
rubber bearing and influence of bearing parameters viz. post-to-pre yield
stiffness ratio and yield displacement on the isolation damping of a six storey
reinforced concrete building excited undirectionally with ground motions having
different characteristics.
FILLED
RUBBER BEARINGS
The
isolation system considered in this study is elastomeric bearing. The most
common elastomers used in elastomeric bearings are natural rubber, neoprene
rubber, butyl rubber and nitrile rubber. The mechanical properties of natural
rubber are superior to those of most synthetic elastomers used for seismic
isolation bearings. Therefore natural rubber is most frequently recommended
material for use in elastomeric bearings followed by neoprene. Butyl
rubbers are suitable for low temperature applications and nitrile rubber have
limited application in offshore oil structure.
METHOD
OF ANALYSIS OF BASE ISOLATED BUILDING
The
time history analysis of the base isolated building is carried out using the
computer program 3D-BASISTABS. A full three-dimensional representation of the
structure is used in time history analysis of the base isolated buildings. The
isolation system is modelled as a bilinear hysteretic element. The details of
method of analysis are described by Reinhorn et al. (1994). Following
assumptions are made for the analysis of base isolated building:
·
The superstructure is
elastic at all time and the non-linear behaviour is restricted in isolators
only.
·
All frame substructures
are connected at each floor level by a diaphragm, which is infinitely rigid in
its own plane.
·
Each floor has three degrees
of freedom (two translations and one rotation) attached to the centre of mass
of each floor. The isolation devices are rigid in the vertical direction and
each has negligible torsion resistance.
·
Effect of infilled walls
on stiffness of the structure is negligible. These are considered in
computation of mass only..
CONCLUSIONS
Filled
rubber bearings are suitable for ground motions having high dominating
frequencies but is not effective for ground motions whose dominant frequencies
are close to natural frequency of base isolated structure. The fundamental
period for a bearing is unique for given bearing parameters but the damping is
found to be dependent upon the characteristics of input ground motion also.
Yield displacement can be used as an important parameter for controlling
damping in order to achieve desired base displacement.